MicroNet SP3501AM Manual do Utilizador

User’s Manual VDSL CO / CPE Modem Model No.: SP3501AM/SP3501AS http://www.micronet.info

Table shows the summary of DIP switch configuration. DIP Switch Configuration Note: 1. Don’t switch on or off all pins as it will make the V

Chapter 5 Appendix 5.1 Cable Requirements A CAT 3, 4 or 5 UTP (unshielded twisted pair) cable is typically used to connect the Ethernet device to th

it consists of six pins. POTS (plain old telephone services) use pins 3 and 4 for voice transmission. A telephone cable is shown below. The A and

5.2 Specifications Model SP3501AM SP3501AS Standards z IEEE802.3 10BASE-T and IEEE802.3u 100BASE-TX standards z ETSI, ITU and ANSI standards Interfa

5.3 Troubleshooting y Symptom: Power indictor does not light up (Green). ¾ Causes: Defective external power supply. ¾ Solution: Check the power pl

y Symptom: S0 bus from an NTBA - data works, but ISDN telephone does not. ¾ Solution: Connect according to the following chart for connecting CO an

Transmission Mode The default method of selecting the transmission mode for RJ-45 port is 10/100 Mbps and for RJ-11 port is 5/15/25Mbps. Therefore,

Table of Contents Chapter 1 Introduction... 1 1.1 Package Contents...

Chapter 1 Introduction Micronet SP3501AM / SP3501AS delivers cost-effective and high-performance broadband access to multiunit building environments

y Fixed/Auto speed function for VDSL link y Built-in POTS/ISDN splitter (SP3501AM) for POTS/ISDN telephone service 2

Chapter 2 Installation 2.1 Hardware Installation This section describes how to install the Modem and establish network connections. Users may instal

VDSL Port (RJ-11) y 24-26 Gauge phone wiring y Do not recommend 28 or above Gauge y 5M/5M: 1.9km y 15M/15M: 1.3km y 25M/M: 800m 2.4 Connecting the

y The Modem’s RJ-11 ports are easy-to-use and do not require installation of additional wiring. Every RJ-11 modular phone jack in the home can becom

Chapter 3 Physical Description SP3501AM/SP3501AS front view SP3501AM/SP3501AS rear view 3.1 LED Definition LED Status Operation PWR (Power LED)

Chapter 4 Speed Configuration 4.1 Fixed/Auto Speed Function SP3501AM/S is a 4-band VDSL solution which supports auto and manual speed function and