MicroNet SP698A Manual do Utilizador

User’s Manual Gigabit Smart Switch Model No.: SP698A http://www.micronet.info

9There are two modes to choose in flow control, including Enable and Disable. If flow control is set Enable, both parties can send PAUSE frame to the

10 3.6 Trunk Configuration This switch provides 2 trunk groups. Simply by press [Enter] key to enable Trunk groups. Port-1 and port-2 belong to “Tr

11Mirror and Trunk functions cannot be enabled simultaneously. For example, when you activate Port 1 Trunking Function, you cannot use Port1 for as M

12To save your settings and disconnect the connectivity simultaneously, use [Tab] to select and press [Enter] to activate. Note: Please note that you

134. Specifications Standard IEEE802.3, IEEE802.3u, IEEE802.3ab IEEE802.3x flow control Interface 8 * RJ-45 ports (10/100/1000M) 1 * RS-232 console

1Table of Content ------------------------------------------------------------------------------------------------------------------------- 1. Intro

21. Introduction This switch provides 8 Gigabit Ethernet ports to offer an economical way for small to medium business users to benefit from the inc

3 Support console port for management  Standard 19" rack-mount size, one-unit-height 1.3 Physical Description Front view POWER LED This

42. Installation 2.1 Preparing the Site Select the site that meets the following requirements: Characteristic Requirement Temperature 32 to 122

5Step 3: Connect one end of the cable to the switch and the other end to a desired device. Step 4: Once the connections between two end-devices are m

63. Console Interface Configuration 3.1 Setting UP Connection Users can configure the switch in command line via console port. The operating mode

7Port Mirror Configuration Configure source port and target port for mirroring. Reset and Save Save the configured values or reset the switch. Exi

8z Jumbo Packet: Select Jumbo Packet for 9K, 12K or disable Jumbo Packet. 3.4 Port Status Ports Configuration is applied to change the setting of