MicroNet Fibre to SAS/SATA II RAID Subsystem Manual do Utilizador descarregar pdf (Página 32)

Fibre to SAS/SATA II RAID Subsystem

User Manual

3.2 Disk Drive Installation

This section describes the physical locations of the hard drives supported by the

subsystem and give instructions on installing a hard drive. The subsystem supports

hot-swapping allowing you to install or replace a hard drive while the subsystem is

running.

3.2.1 Installing a SAS Disk Drive in a Disk Tray

NOTE: These steps are the same when installing SATA disk drive in

Single Controller Mode.

1. Press the Tray Open button and the Disk Tray handle will flip open.

2. Pull out an empty disk tray. Pull the handle outwards to remove the tray from the

enclosure.

3. Place the hard drive in the disk tray. Make sure the holes of the disk tray align

with the holes of the hard drive.

Tray

Open

Button

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 137 138

Sem comentários

MicroNet Fibre to SAS/SATA II RAID Subsystem Manual do Utilizador Página 32