MicroNet Fibre to SAS/SATA II RAID Subsystem Manual do Utilizador descarregar pdf (Página 36)

Fibre to SAS/SATA II RAID Subsystem

User Manual

Chapter 4 RAID Configuration Utility Options

Configuration Methods

There are f o u r methods of configuring the RAID controller:

VT100 terminal connected through the serial Monitor port

Front panel touch-control buttons

Web browser-based remote RAID management via the R-Link Ethernet port

Telnet connection via the R-Link Ethernet port

NOTE: The RAID subsystem allows you to access using only one

method

at a time. You cannot use more than one method at the

same time.

4.1 Configuration through Terminal

Configuring through a terminal will allow you to use the same configuration options

and functions that are available from the LCD panel and via Telnet. To start-up:

1. Connect the Monitor port located at the rear of the system to a PC or a VT100

compatible terminal operating in an equivalent terminal emulation mode using serial

cable.

NOTE: You may connect a terminal while the system’s power is on.

2. Power-on the terminal.

3. Run the VT100 program or an equivalent terminal program.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 137 138

Sem comentários

MicroNet Fibre to SAS/SATA II RAID Subsystem Manual do Utilizador Página 36