Communicate via
P/N 2300-0637
Quick Installation Guide
Model No.: SP6824P
24-port 10/100Mbps Layer 2
Managed Switch With 370W
PoE output power
6
5
7
WEEE Directive & Product Disposal
At the end its serviceable life ,this product should not be treated
as household or general waste. It should be handed over to the
applicable collection point for the recycling of electrical and
electronic equipment, or returned to the supplier for disposal.
Hardware Installation
Connecting to the Console Port and Ethernet Port
1. Attach one end of the supplied RS-232 cable to PC or terminal
and the other end to the console port of the SP6824P front panel.
The connected terminal or PC must support the terminal
emulation program.
2. Connect one end of an RJ-45 cable to the Ethernet port at the
front panel and the other end to PC or terminal for web interface
management.
Cabling Requirements for 1000Base-SX/LX SFP Module
SP6824P supports the more complex and comprehensive TP
cabling in the fiber media. Basically, there are two categories of fiber,
multimode and single mode. The later is categorized into several
classes by the distance supported. They are SX, LX, LHX, XD and
ZX. From the viewpoint of connector type, there mainly are LC and
Bi-Di LC.
Gigabit Fiber with multimode LC SFP module
Gigabit Fiber with single-mode LC SFP module
Gigabit Fiber with Bi-Di LC 1310nm SFP module
Gigabit Fiber with Bi-Di LC 1550nm SFP module
For more details, please refer to user manual.
1.
1.
1.
1.
1.
Configuration
Web-based User Interface
Before using web management, install the SP6824P on the network
and make sure that any one of the PCs on the network can connect
with the SP6824P through the web browser. The default IP, subnet
mask, username and password are as follows:
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
User Name: admin
Password: [leave blank]
Login in the Console Interface
When the connection between SP6824P and PC is ready, turn on
the PC and run a terminal emulation program or Hyper Terminal and
configure its communication parameters to match the following
default characteristics of the console port:
Baud Rate: 38400 bps
Data Bits: 8
Parity: none
Stop Bit: 1
After finishing the parameter settings, click “OK“. When the blank
screen shows up, press Enter key to bring out the login prompt.
Key in the “admin“ (default value) for the User name and leave the
Password field blank (use Enter key to switch), then press Enter
key and the command line interface of console management
appears.
----------For more details, please refer to user manual.--------
CE Mark Warning
This equipment complies with the requirements relating to
electromagnetic compatibility of the essential protection
requirement of Council Directive 89/336/EEC on the approximation
of the laws of the Member States. Company has an on-going policy
of upgrading its products and it may be possible that information in
this document is not up-to-date. Please check with your local
distributors for the latest information. No part of this document can
be copied or reproduced in any form without written consent from
the company.
www.micronet.com.tw
(24 páginas)
(118 páginas)
(8 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais